The list below shows the results. Besides, it supports booting from the CD. The second, an orange one, shows that the card is connected to the Mbit network. With a little more work, Asus could make it a great board. I canceled the benchmark, went to Windows, and ran the Norton benchmark. In fact, the system showed normal, low variability most of the time, but on occasion, would show increased variability in benchmark results.

Uploader: Sazragore
Date Added: 20 July 2011
File Size: 28.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 58149
Price: Free* [*Free Regsitration Required]

You will also notice the dip in the dark blue line at the 4th test above. I observed no glitches, and the system ran everything without hanging, or dropping to the desktop. For such cases ASUS offers its own one.

Pentium III overclock stability seemed better than Celeron-2 overclockability, but we did not have extra Celeron-2s mothergoard to ucv4x, so we can’t say for sure. The motherboard correctly recognized the chip, and booted up still a noticeably long boot time. The overall boot time was also longer than normal for a clean system.

Even a usage of a long AGP video card does prevent their access. An integrated network controller can be disabled with a jumper on the board. So I used the E flip-chip for stability testing while overclocking the bus frequency.


Note that the UDMA modes gives a noticeable performance mltherboard. That means when you turn the system on in the morning, it will be almost 20 seconds before you can tell that it has responded! The most overclockable Pentium IIIs are the E and E models, which often will run at MHz on the front side bus, if the motherboard and memory can handle it too.

The Athlon system running on a VIA chipset motherboard showed very little variability. It’s a serious claim for the market of high-efficient PCs, work stations and entry-level servers.

ASUS CUV4X-E, Socket 370, Intel Motherboard

Unfortunately, at the time of this review, we only had 1 Celeron-2 chip available for testing, so I’m not sure if these results are typical. With the following raise of the frequency the system hung in the Quake3 20 minutes later.

The layout is rather compact due to two sockets, SCSI and network controller. Unfortunately, even with a core voltage of 1.

ASUS CUV4X, Socket , Intel Motherboard | eBay

The chipset is equipped with a small heatsink without gluebut it didn’t heat much during the tests. The system benchmarks did not increase when going from MHz to MHz on the bus frequency, probably because the memory speed had to be reduced.


However, overclocking stability was very good with the CUV4X. Video 3Digests Video cards: Despite the fact that the board supports WOL it doesn’t work with the integrated network adapter.

But I did not see any drop in performance, or variability of results, after running 3D Mark on that machine. The initial setup included: However, in fact the PIO mode was enabled. The advanced users can enable the AGP 4X mode having adjusted the register: After that we adjusted memory and CPU frequencies. Finally, I put a new Celeron flip-chip in the system, and tested for variation in the Norton benchmark.

With the Celeron-2, the benchmark numbers were very stable, and almost no variation was seen. You can’t rise the Vcore and Vio. The Y axis is exaggerated again. A CPU terminator is mounted into the second socket. Besides, for two MHz systems we received quite low scores. But it doesn’t hinder installation in any standard case. But before you should get sure that BIOS allows using this mode.